TU Delft login

SPS Spin 150 Spincoater

Previous Page back |Print Document print | 284 of 357 | « previous | next »

Spincoater_Mol.jpg

Contact details

Mol, J.M.C. (Arjan) Dr.
Mechanical, Maritime and Materials Engineering (3mE), Surfaces and Interfaces Group
Mekelweg 2, 2628 CD Delft
Tel : +31 (0)15 27 86778
E-mail : J.M.C.Mol@tudelft.nl
Website : Open website

General Information

Instrument:

SPS Spin 150 Spincoater

Location:

Surfaces & Interfaces lab, Department of Materials Science and Engineering, Faculty of Mechanical, Maritime and Materials Engineering, Mekelweg 2, Delft (building #34)

Key words:

Spin coating

Main application:

Application of coatings on substrates via spinning process

Instrument specification

Full-Plastic System in Polypropylene
Table-Top Model (Footprint: 39cm x 28cm)
Process Chamber Diameter: 200mm
Substrate size: fragments and substrates up to Ø150mm (6”)
Transparent Lid with Central Nitrogen Diffuser with Syringe Holder provision
2 Programmable Switch Contacts: Dispense On/Off, Nitrogen On/Off
Manual Chemical Dispense
Easy, step-by-step Programming via Gloved-Finger-Friendly Keyboard 
with LED Backlit Display
Programmable Digital Process Controller, 
Programmable Storage of 20 Programs with 99 steps / each for: 
Time 1-999 sec/step, Speed 1-6.000 RPM +/- 1 RPM, 
Acceleration/Dec. 1-3.000 RPM/Sec +/- 1 RPM/Sec., Vacuum On/Off
2 Programmable ON/OFF Switching Outputs 
e.g. for Dispense On/Off, Nitrogen On/Off, etc.
Digitally controlled Motor with digital incremental speed signal feed back 
CE-approved

Amount of instruments installed:
One, owned by S&I group

Additional information:
The apparatus can only be used after appointment when not used by members of the S&I group.